The client wanted to install a weighing system on its ladle turret. It was a difficult brief: three different vendors had already tried, and none had achieved acceptable accuracy. In 20 years, no solution had succeeded on the turret.
The turret is a harsh environment for any measuring instrument. Load cells sit close to molten steel and must survive:
• Extreme heat radiating from the ladle and surrounding process.
• Heavy impact loads each time a full ladle is placed on the turret arm.
• A rotating structure, which makes signal and data transfer difficult.
Measuredi Technologies took up the challenge. Our team visited the site to understand the requirements and the practical difficulties of installing a weighing system on the turret.
We then held detailed discussions across every department involved (mechanical, electrical, electronics and operations) to understand why the three previous attempts had not worked. The inputs from each department shaped the design, which we presented to the client.
The final design addressed the root causes of the earlier failures directly, and the client was impressed with the result. It provides:
• Protection from high temperature: The weigh module is enclosed under a cover with heat-protection material and a nitrogen cooling arrangement.
• Protection from impact load: The module is designed to shield the load cell from shock when the ladle is seated.
• Wireless Data Transmission: Weight data is sent from the turret to the weighing controller through an RF modem, removing the need for cabling across the moving structure.
Fig. 1 – Design of the weigh module on the ladle turret resting arm
After delivery, the installation and commissioning were carried out carefully in stages, starting with preparation of the existing ladle turret resting arm.
Fig. 2 – Preparing the existing resting arm
Fig. 3 – Site work to fit the weigh module
Fig. 4 – Weigh modules placed on the resting arm
The weigh module was then closed with a cover containing the required heat-protection material, together with a nitrogen cooling arrangement.
Fig. 5 – Weigh module with closed protective cover
Fig. 6 – Cover and cooling line in position
Fig. 7 – Ladle seated on the turret arm during operation
Fig. 8 – Weighing controller (turret weighing system panel)
Fig. 9 – RF modem for wireless data transfer
After installation, we tested the system using standard calibration weights. It met the specified accuracy, and the client was very pleased with the design.
We sincerely thank the client and their team for their extensive support, which contributed greatly to the success of the Ladle Turret Weighing System project.

Fig. 9 – The Measuredi Technologies Team With the ground Force Team
The client was extremely satisfied with our design, service and after-sales support, and placed a repeat order for another caster.
Portrait Mode, Please.